Mitsubishi Electric MELSERVO-J3W Series, Инструкция по эксплуатации

Страница: 92 / 500

5. PARAMETERS
5 - 5
5.1.5 Using absolute position detection system
Parameter
No. Symbol Name
Setting
Factory
setting
Unit
Setting
range
PA03 *ABS Absolute position detection system Each axis 0000h
Refer to
the text.
POINT
Turn off the power and then on again, or reset the controller after setting the
parameter to validate the parameter value.
This parameter cannot be used in the speed control mode.
Set this parameter when using the absolute position detection system in the position control mode.
Selection of absolute position detection system (refer to chapter 12)
0: Used in incremental system
1: Used in absolute position detection system
Parameter No.PA03
0 0 0
5.1.6 Forced stop input selection
Parameter
No. Symbol Name
Setting
Factory
setting
Unit
Setting
range
PA04 *AOP1 Function selection A-1 Common 0000h
Refer to
the text.
POINT
Turn off the power and then on again, or reset the controller after setting the
parameter to validate the parameter value.
The servo forced stop function is avoidable.
Selection of servo forced stop
0: Valid (Forced stop (EM1) is used.)
1: Invalid (Forced stop (EM1) is not used.)
Parameter No.PA04
0 0 0
When not using the forced stop (EM1) of servo amplifier, set the selection of servo forced stop to Invalid ( 1
). At this time, the forced stop (EM1) automatically turns on inside the servo amplifier.