Mitsubishi Electric MELSERVO-J3W Series, Инструкция по эксплуатации

Страница: 374 / 500

14. USING A DIRECT DRIVE MOTOR
14 - 41
14.6 Troubleshooting
POINT
If an alarm which indicates each axis in the stop method column occurs, the axis
without the alarm operates the servo motor as per normal.
If an alarm/warning has occurred, refer to this section and remove its cause.
14.6.1 Alarm and warning list
When an error occurs during operation, the corresponding alarm or warning is displayed. Refer to section 14.6.2
and 8.3 for alarms, and section 14.6.3 and 8.4 for warnings to take an appropriate action. When an alarm occurs,
ALM-A/ALM-B will turn off.
After its cause has been removed, the alarm can be deactivated in any of the methods marked in the alarm
deactivation column. Warnings are automatically canceled after the cause of occurrence is removed.
Alarm deactivation
Display Name Power off
to on
Error
reset
CPU reset
Detection
system
(Note 3)
Stop
system
(Note 4)
10 Undervoltage Common All axes
11 Switch setting error Common All axes
12 Memory error 1 (RAM) Common All axes
13 Clock error Common All axes
15 Memory error 2 (EEP-ROM) Common All axes
16 Encoder initial communication error 1 Each Each
17 Board error Common All axes
19 Memory error 3 (Flash-ROM) Common All axes
1A Motor combination error Each Each
1E Encoder initial communication error 2 Each Each
1F Encoder initial communication error 3 Each Each
20 Encoder normal communication error 1 Each Each
21 Encoder normal communication error 2 Each Each
24 Main circuit error Each All axes
25 Absolute position erased Each Each
27 Initial magnetic pole detection error Each Each
2B Encoder counter error Each Each
30 Regenerative error
(Note 1) (Note 1) (Note 1)
Common All axes
31 Overspeed Each Each
32 Overcurrent Each All axes
33 Overvoltage Common All axes
34 SSCNET receive error 1
(Note 2)
Each Each
35 Command frequency error Each Each
36 SSCNET receive error 2 Each Each
37 Parameter error Each Each
42 Servo control error
(Note 5) (Note 5)
Each Each
Ala
rm
45 Main circuit device overheat
(Note 1) (Note 1) (Note 1)
Common All axes