Mitsubishi Electric MELSERVO-J3W Series, Инструкция по эксплуатации

Страница: 369 / 500

14. USING A DIRECT DRIVE MOTOR
14 - 36
14.5.6 Special setting parameters (No.PS
)
(1) Parameter list
POINT
The parameter whose symbol is preceded by * is enabled with the following
conditions:
*: After setting the parameter, cycle the power or reset the controller.
**: After setting the parameter, cycle the power.
No. Symbol Name
Each/
common
(Note 1)
Default
value
(Note 2)
Unit Reference
PS01 **LIT1 Special function selection 1 Each 0301h (2) of this
section
PS02 This parameter is not used. Do not change this value by any means. 1000
PS03 1000
PS04 *LIT2 Special function selection 2 Each 0003h
PS05 LB1 Servo control position deviation error detection level Each 0 0.01
rev
(2) of this
section
PS06 LB2 Servo control speed deviation error detection level Each 0 r/min
PS07 LB3 Servo control torque deviation error detection level Each 100
PS08 *LIT3 Special function selection 3 Each 0010h
PS09 LPWM Magnetic pole detection voltage level Each 30
PS10 This parameter is not used. Do not change this value by any means. 5
PS11 100
PS12 500
PS13 0000h
PS14 0
PS15 0000h
PS16 0000h
PS17 LTSTS Minute position detection method function selection Each 0000h
PS18 IDLV Minute position detection method identification signal amplitude Each 0000h
(2) of this
section
PS19 This parameter is not used. Do not change this value by any means. 0000h
PS20 0000h
PS21 0000h
PS22 0000h
PS23 0000h
PS24 0000h
PS25 0000h
PS26 0000h
PS27 0000h
PS28 0000h
PS29 0000h
PS30 0000h
PS31 0000h
PS32 0000h
Note 1. Each: Set parameters for each axis of A and B.
Common: Set parameters for common axis of A and B. Be sure to set the same value to the both axes. When the setting values are
different, the value set at last will be enabled.
2. The values are common in A-axis and B-axis.