Mitsubishi Electric MELSERVO-J3W Series, Инструкция по эксплуатации

Страница: 295 / 500

13. USING A LINEAR SERVO MOTOR
13 - 46
No. Symbol Name
Setting
(Note 1)
Factory
setting
(Note 2)
Unit
Reference
PC27 **COP9 Function selection C-9 Each
axis
0000h This
section
(2)
PC28 This parameter is not used. Do not change the value. 0000h
PC29 0000h
PC30 0000h
PC31 0000h
PC32 0000h
Note 1. Each axis: Set a value for each of the A-axis and the B-axis.
Common: Common parameters for the A-axis and the B-axis. Set same values for the A-axis and the B-axis. If different values are
set, the last set value becomes valid.
2. Valid for the A-axis and the B-axis.
(2) List of details
No. Symbol Name Setting
Factory
setting
Unit
Setting
range
PC01 ERZ Error excessive alarm level
This parameter cannot be used in the speed control mode.
Used to set the error excessive alarm level in mm unit.
When "0" is set in this parameter, the alarm level is 3mm. When a value other
than "0" is set, the alarm level is the amount of the set value. However, the alarm
level stays at 200mm even if a value exceeding "200" is set.
Note. Setting can be changed in parameter No.PC06. Each
axis
0 mm
(Note)
Refer to
name
and
function
column.
PC03 *ENRS Encoder output pulse selection
Use to select the, encoder output pulse direction and encoder pulse output
setting.
Negotive direction
Encoder output pulse phase changing
Changes the phases of A/B-phase encoder output pulses.
A-phase
B-phase
Positve direction
Linear Servo motor moving direction
Set value
0
1
Encoder output pulse setting selection
0: Not used for the linear servo motor.
When this value is set, the parameter error (37.2) occurs.
3: A/B-phase pulse electronic gear setting
(Set with the electronic gear parameter No.PA15 and PA16.)
0 0
A-phase
B-phase
A-phase
B-phase
A-phase
B-phase
Each
axis
0010h Refer to
name
and
function
column.
PC04 **COP1 Function selection C-1
Select the encoder cable communication system selection.
0 0
Encoder cable communication system selection
0: Two-wire type
1: Four-wire type
Incorrect setting will result in an encoder alarm 1 (16.3).
0
Each
axis
0000h Refer to
name
and
function
column.