Mitsubishi Electric MELSERVO-J3W Series, Инструкция по эксплуатации

Страница: 307 / 500

13. USING A LINEAR SERVO MOTOR
13 - 58
13.7 Troubleshooting
POINT
When an alarm with "Each axis" indicated in the "Stop method" column occurs, the
servo motor in the non-alarm-occurring axis can continue running.
If an alarm/warning has occurred, refer to this chapter and remove its cause.
13.7.1 Alarms and warning list
When an error occurs during operation, the corresponding alarm or warning is displayed.
If any alarm has occurred, refer to section 13.7.2 and section 8.3; if any warning has occurred, refer to section
13.7.3 and section 8.4, and take the appropriate action. When an alarm occurs, ALM-A/ALM-B turns OFF.
After its cause has been removed, the alarm can be deactivated in any of the methods marked in the alarm
deactivation column.
Alarm deactivation
Display Name
Power
OFF ON
Error reset CPU reset
Detection
method
(Note 3)
Stop
method
(Note 4)
10 Undervoltage Common All axis
11 Switch setting error Common All axis
12 Memory error 1 (RAM) Common All axis
13 Clock error Common All axis
15 Memory error 2 (EEP-ROM) Common All axis
16 Encoder initial communication error 1 Each axis Each axis
17 Board error Common All axis
19 Memory error 3 (Flash-ROM) Common All axis
1A Motor combination error Each axis Each axis
1E Encoder initial communication error 2 Each axis Each axis
1F Encoder initial communication error 3 Each axis Each axis
20 Encoder normal communication error 1 Each axis Each axis
21 Encoder normal communication error 2 Each axis Each axis
24 Main circuit error Each axis All axis
27 Initial magnetic pole detection error Each axis Each axis
28 Linear encoder error 2 Each axis Each axis
2A Linear encoder error 1 Each axis Each axis
30 Regenerative error (Note 1) (Note 1) (Note 1) Common All axis
31 Overspeed Each axis Each axis
32 Overcurrent Each axis All axis
33 Overvoltage Common All axis
34 SSCNET receive error 1 (Note 2) Each axis Each axis
35 Command frequency error Each axis Each axis
36 SSCNET receive error 2 Each axis Each axis
37 Parameter error Each axis Each axis
42 Linear servo control error (Note 5) (Note 5) Each axis Each axis
45 Main circuit device overheat (Note 1) (Note 1) (Note 1) Common All axis
46 Linear servo motor overheat (Note 1) (Note 1) (Note 1) Each axis Each axis
47 Cooling fan error Common All axis
50 Overload 1 (Note 1) (Note 1) (Note 1) Each axis Each axis
51 Overload 2 (Note 1) (Note 1) (Note 1) Each axis Each axis
52 Error excessive Each axis Each axis
8A USB communication time-out error Common All axis
8E USB communication error Common All axis
Ala
rms
888 Watchdog Common All axis