Mitsubishi Electric MELSERVO-J3W Series, Инструкция по эксплуатации

Страница: 107 / 500

5. PARAMETERS
5 - 20
No. Symbol Name and function Setting
Factory
setting
Unit
Setting
range
PC11 MO1 Analog monitor 1 offset
Used to set the offset voltage of the analog monitor 1 (MO1) output. Common 0 mV 9999
to
9999
PC12 MO2 Analog monitor 2 offset
Used to set the offset voltage of the analog monitor 2 (MO2) output. Common 0 mV 999
to
999
PC13 This parameter is not used. Do not change the value. 0
PC14 0
PC15 SNO Station number selection
Used to select the axis to communicate with MR Configurator.
0: A-axis
1: B-axis Common 0
PC16 This parameter is not used. Do not change the value. 0000h
PC17 **COP4 Function Selection C-4
This parameter cannot be used in the speed control mode and the torque
control mode.
This is used to select a home position setting condition.
Selection of home position setting condition
0: Need to pass motor Z-phase after the power
supply is switched on.
1: Not need to pass motor Z-phase after the power
supply is switched on.
0 0 0
Each
axis
0000h Refer to
Name
and
function
column.
PC18 This parameter is not used. Do not change the value. 0000h
PC19 0000h
PC20 0000h
PC21 *BPS Alarm history clear
Used to clear the alarm history.
Alarm history clear
0: Invalid
1: Valid
When alarm history clear is made valid, the alarm
history is cleared at next power-on.
After the alarm history is cleared, the setting is
automatically made invalid (reset to 0).
0 0 0
Each
axis
0000h Refer to
Name
and
function
column.
PC22 This parameter is not used. Do not change the value. 0000h
PC23 0000h
PC24 0000h
PC25 0000h
PC26 0000h
PC27 0000h
PC28 0000h
PC29 0000h
PC30 0000h
PC31 0000h
PC32 0000h