LSIS XBF-PN04B, Руководство пользователя

Страница: 421 / 820

Chapter 8 Program
8-139
8.2.8 Error
(1) Error Reset
(a) This is the condition for Error Reset
This is the condition for Error Reset Command (XPM_RST). Once Error Reset is executed, it erases errors of
module form each axis.
(b) Axis ready
If communication between the positioning module and the servo driver is normal, corresponding signal will be
on.
(c) Error state for each axis
According to exercise from “Chapter 8.2.2 Current State Reading,” it is a signal of “Error state” for each axis. It
turns on when an error occurred. Operation will only work when there is no er ror. If you want to operate a
system regardless of errors, you can just inactivate the function.
(d) Address of Positioning Module
In this example, Positioning Module is installed at the 3 slot of 0 bases.
(e) Axis of command execution
You can set an axis for Parameter Setting. XBF-PN04(8)B supports for 4(8) axes. In the “execution of axis”
from the configuration of Parameter Setting, you can set a value for axis1 through axis4(8).
(f) Error setting of Error/Common by axis
Depending on the errors, if it is set by “0”, erase the errors in operation of each axis, if it is set by “1”, erase the
common errors of each modules.
(g) State of Operation complete
If function block is completed without error, “1” will be outputted and m aintain “1” until the next operation. If
error occurred, “0” will be outputted.
(h) Error State
This is the area that output error no. if there are errors in operation of function block.
(a) Condition for error reset
(b) Axis ready state
(d) Position of the module
(g) Completion state
(e) Command axis
(f) Axis error/ common error setting
(c) Error state
(h) Error state