JUMO flowTRANS MAG H01, Руководство по эксплуатации

Страница: 84 / 260

7 Startup
84
7.5 Starting up the device
7.5.1 Loading the system data
1. Switch on the voltage supply. After switching on the voltage supply, the following messages are dis-
played consecutively in the LCD display:
2. Download the system data as follows:
For a completely new system or initial startup
The calibration data of the sensor and the transmitter settings are loaded from the SensorMemory
1
-
into the transmitter.
After replacing the complete transmitter or transmitter electronics unit
Use to select "Transmitter". The calibration data of the sensor and the transmitter settings are
loaded from the SensorMemory into the transmitter.
After replacing the transmitter (sensor)
Use to select "Sensor". The calibration data of the sensor is loaded from the SensorMemory
into the transmitter. The transmitter settings are saved in the SensorMemory. If the new sensor has
a different nominal width, the measuring range setting must be checked.
3. The flowmeter is now ready for operation and operates with default settings or the pre-configured
settings requested by the customer depending on the order. To change the default settings,  see
chapter 8 "Parameterization", page 95
1
The SensorMemory is a memory integrated in the sensor.
IMPORTANT (NOTE)!
System data must only be loaded during initial startup. If the voltage supply is switched off at a later time,
the transmitter automatically loads all the data the next time the voltage supply is switched on again. A
selection, as described below (1-3), is not required.