JUMO flowTRANS MAG H01, Руководство по эксплуатации

Страница: 80 / 260

7 Startup
80
7.4 Startup for FOUNDATION Fieldbus devices
For devices using FOUNDATION Fieldbus, the DIP switch settings must be checked prior to startup.
The DIP switches on the device must be set correctly:
•
DIP switch 1 must be set to OFF.
• DIP switch 2 must be set to OFF.
Otherwise, hardware write protection is effective, and the process control system cannot write the data
to the device.
DIP switch position
 See figure chapter 7.4.1 "Configuration for transmitters with a dual-compartment
housing", page 81.
For integration with the process control system, a DD (device description) file, containing the device de-
scription and a CFF (Common File Format) file are required. The DD file contains the device description.
The CFF file is required for engineering the segment. Engineering can occur online or offline.
The device's FOUNDATION Fieldbus interface complies with the standards FF-890/891 and FF-902/90.
The transmitter's transmission signal is designed for compliance with IEC 61158-2.
The device is registered with the Fieldbus Foundation.
The registration with the Fieldbus Foundation is recorded under Manufacturer ID 0x000320 and Device
ID 0x0124.
IMPORTANT (NOTE)!
The files required for operation are included on the CD, or can be downloaded from www.jumo.de.