75
7 Startup
7.2.2
Transmitter - single-compartment housing
Configure the outputs as follows:
1. Switch off the voltage supply.
2. Open the case lid.
3. Remove the fastening screws for the transmitter electronics unit.
4. Pull out the transmitter electronics unit.
5. Set jumpers on the backplane according to the following table.
6. Reinstall the transmitter electronics unit in reverse order.
A
JUMO flowTRANS MAG S/H - compact design
B
JUMO flowTRANS MAG - remote mount design
(1)
Case lid
(2)
Transmitter plug-in module
(3)
Mounting screws
(4)
Backplane (in the transmitter housing)
(5)
Jumper (BR905, BR906) for communication
(6)
Jumper (BR901) for active/passive current output
(7)
Jumper (BR904) for active/passive pulse output
(8)
Jumper (BR903) for integral/remote mount design
(9)
Jumper (BR902) for hardware write protection
IMPORTANT (NOTE)!
The backplane is mounted in the transmitter housing (not the transmitter plug-in module).
Содержание flowTRANS MAG H01
