JUMO flowTRANS MAG H01, Руководство по эксплуатации

Страница: 55 / 260

55
5 Electrical connection
5.3 Assembling the signal and magnet coil cable - single-compartment
housing
Assemble the cable end on the transmitter side as displayed in the figure.
IMPORTANT (NOTE)!
Use ferrules.
•
Ferrules 0.75 mm2 (AWG 19), for the shielding (1S, 2S)
• Ferrules 0.5 mm2 (AWG 20) for all other wires
• Twist the wire mesh shield of the cable and connect to the grounding terminal.
• Connect the ground wire of the cable to the SE clamp of the terminal strip.
• Connect all other wires as displayed in the figure below.
CAUTION – Device damage!
The shields may not touch. Otherwise, a signal short circuit occurs.
Transmitter side
(1) Ground wire
(2) Wire mesh shield
(4) Twisted wire mesh shield
Terminal Description, wire color Length in mm (inch)
M1 Magnet coil, brown 70 (2.76)
M2 Magnet coil, red 70 (2.76)
D1 Data line, orange 70 (2.76)
D2 Data line, yellow 70 (2.76)
SE Shielding -
3 Measurement potential, green 70 (2.76)
2S Shield of E2 60 (2.36)
E2 Signal line, blue 60 (2.36)
E1 Signal line, violet 60 (2.36)
1S Shield of E1 60 (2.36)
G01323
M1 M2 D1 D2 SE 3 2S E2 E1 1S
(1)
(2)
(4)