JUMO flowTRANS MAG H01, Руководство по эксплуатации

Страница: 183 / 260

183
13 Technical data
13.2 Sensor JUMO flowTRANS MAG S01/02
13.2.1 Temperatures
The temperature range of the device depends on a series of factors. These factors include the measure-
ment medium temperature, the ambient temperature, the operating pressure, the lining material, and the
approvals for the Ex-protection.
13.2.2 Storage temperature
-40 to +70 °C (-40 to +158 °F)
13.2.3 Minimum admissible pressure depending on the medium temperature
Sensor housing made of aluminum (double shell housing)
Sensor housings made of steel
13.2.4 Maximum admissible cleaning temperature
If the ambient temperature is > 25 °C, the difference must be subtracted from the max. cleaning tem-
perature. T
max
- ∆ °C. (∆ °C = T
Amb
- 25 °C)
Lining Nominal width p
Operation
abs for T
Operation
a
a
Higher temperatures are allowed for CIP/SIP cleaning for a limited time (  See table 13.2.4).
Hard rubber DN 15 to 2000 (1/2 to 80″) 0 mbar < 90 °C (194 °F)
Soft rubber DN 50 to 2000 (2 to 80″) 0 mbar < 60 °C (140 °F)
PTFE DN 10 to 600 (3/8 to 24″)
270 mbar < 20 °C (68 °F)
400 mbar < 100 °C (212 °F)
500 mbar < 130 °C (266 °F)
Thick PTFE
DN 25 to 80 (1 to 3″) 0 mbar < 180 °C (356 °F)
DN 100 to 80 (4 to 10″) 67 mbar < 180 °C (356 °F)
DN 300 (12″) 27 mbar < 180 °C (356 °F)
PFA DN 3 to 200 (1/10 to 8″) 0 mbar < 180 °C (356 °F)
ETFE DN 25 to 600 (1 to 24″) 100 mbar < 130 °C (266 °F)
Ceramic carbide DN 25 to 1,000 (1 to 40″) 0 mbar < 80 °C (176 °F)
Lining Nominal width p
Operation
abs for T
Operation
a
a
Higher temperatures are allowed for CIP/SIP cleaning for a limited time (  See table 13.2.4).
Hard rubber DN 40 to 600 (1 1/2 to 24″) 600 mbar < 80 °C (176 °F)
PTFE DN 25 to 600 (1 to 24″)
270 mbar < 20 °C (68 °F)
400 mbar < 100 °C (212 °F)
500 mbar < 130 °C (266 °F)
CIP cleaning Lining T
max
T
max
minutes T
amb
Sensor
Steam cleaning PTFE, PFA 150 °C (302 °F) 60 25 °C (77 °F)
Liquids PTFE, PFA 140 °C (284 °F) 60 25 °C (77 °F)