JUMO flowTRANS MAG H01, Руководство по эксплуатации

Страница: 128 / 260

8 Parameterization
128
Italics = Parameter can only be viewed in the "Advanced" password level
Italics = Parameter can only be viewed in the "Advanced" password level
Menu/parameter Value range Description
Input/Output/... Logic Setup/ ... DO1 Alarm Config
General Alarm ON/OFF Each alarm can be enabled separately. This allows
you to individually configure when the digital output
DO1 signals an alarm.
Min. Flowrate Alarm ON/OFF
Max. Flowrate Alarm ON/OFF
Empty Pipe ON/OFF
TFE Alarm ON/OFF
Gas Bubble
a
ON/OFF
Conductivity
a
ON/OFF
Coating
a
ON/OFF
Sensor Temp
a
ON/OFF
a
Only available for JUMO flowTRANS MAG S02/H02
Menu/parameter Value range Description
Input/Output/... Logic Setup/ ... DO2 Alarm Config
- - See description "....DO1 Alarm Config"
Menu/parameter Value range Description
Input/Output/ ... Pulse Setup
Operating Mode Pulse Mode, Fullscale Fre-
quency The menu is only displayed after selecting a "Pulse
..." function below "Input/Output/... Setup Digital
outp./Function DO1/DO2".
Operating mode selection for the digital output
You can choose between two operating modes:
•
"Pulse Mode": in pulse mode, pulses per unit are
output (e.g. 1 pulse per m
3
)
• "Frequency mode": In frequency mode, a fre-
quency proportional to the flow is output; the
maximum frequency can be configured according
to the measuring range end value (maximum
5 kHz).
Default setting: "Pulse Mode"
Pulses per Unit 1 to 5250/s Pulse setting per unit in the "Pulse Mode" operating
mode
Pulse Width 0.1 to 2000 ms Pulse Width setting in the "Pulse Mode" operating
mode
The pulse factor and pulse width are interdependent
and are calculated dynamically.
Limit Frequency Display only Display of pulse output limit frequency
Fullscale Frequency 0 to 5000 Hz Frequency setting for the measuring range end value
in "Fullscale Frequency"