JUMO flowTRANS MAG H01, Руководство по эксплуатации

Страница: 77 / 260

77
7 Startup
7.3.1 Setting the address locally for transmitters with a dual-compartment housing
Switch assignment
Device behavior on switching on the voltage supply
After the voltage supply is switched on, DIP switch 8 is queried:
Address setting
Switches 1, 5, 7 = ON means: 1+16+64 = 81 = Bus address 81
(1) Transmitter plug-in module
(2) DIP switch
Switch Assignment
1 to 7 PROFIBUS address
8 Defining the address mode:
Off = The address is set via the bus (default setting)
On = The address is set via the DIP switches 1 to 7 (locally)
Status
ON The address set by DIP switches 1 to 7 applies.
The address cannot be changed via the bus while the device is operating, because
DIP switch 8 is queried once only when the voltage supply is switched on.
OFF (default) The transmitter starts with the address saved in the FRAM of the gateway. On de-
livery, the address is 126 or the address specified by the customer.
The address can be set via the bus or the push-buttons on the display board on the
device while it is operating. In this case, the device must be connected to the bus.
Switch 1 2 3 4 5 6 7 8
Status Device address Address mode
Off 0 0 0 0 0 0 0 Bus
On 1 2 4 8 16 32 64 Local