JUMO flowTRANS MAG H01, Руководство по эксплуатации

Страница: 147 / 260

147
8 Parameterization
8.5 Alarm Simulation
Different alarms can be simulated in the "Process alarm/alarm simulation" menu.
Menu/Parameter Description
Process alarm/ Alarm simulation
Off Alarm simulation switched off
0-Sim.CurrentOut Simulate current output
1-Sim.Logic on DO1 Switch on/off switching output (terminal 51/52)
2-Sim.Pulse on DO1 Simulate pulse output (terminal 51/52)
3-Sim.Logic on DO2 Switch on/off switching output (terminal 41/42)
4-Sim.Pulse on DO2 Simulate pulse output (terminal 51/52)
5-Min Alarm Flowrate Simulate min. flow alarm
6-Max Alarm Flowrate Simulate max. flow alarm
7-Flowrate >103% Simulate flow > 103 % as an alarm
8-Flow Simulation Simulate flow simulation
9-Calibration Mode Simulate transmitter alarm at the simulator
10-Flowrate to Zero Simulate flowrate to zero
11-Totalizer Stop Simulate external totalizer stop
12-Tot.Display<1600h Simulate display value < 1600 h at Q
max
13-Totalizer Reset Simulate Totalizer Reset
14-Err.Sensor-Comms Simulate distorted communication to the SensorMemory
15-HART Address <> 0 Simulate HART Multiplex mode
16-FRAM-Com Fail
17-No Sensor
Simulate "No communication to SensorMemory" error
18-Sim.Digital Input Simulation of the "ON/OFF" digital input
19-ADC saturated Simulate "AD converter override" error
20-Error Coil circ Simulate error in the coil circuit
21-Coil Resistor Simulate "Coil resistance out of limits" error
22-Driver Err Uref=0 Simulate "Reference voltage = 0" error
23-El.Noise too High Simulate "Noise signal too high" error
24-DC to High Simulate "DC too high, several NV resets" error
25-Empty Pipe Simulate "Empty pipe" error
27-NV Corrupt Simulate "NV Corrupt" error
29-Electrode Imp. Simulate "Electrode impedance out of limits" error
30-Hold Last Value Simulate "Hold last good value" error
32-Digi-Pot Error Simulate "Digital potentiometer" error
33-TFE Simulate "Partial filling alarm" error
34-CurrentOut Error Simulate "Loop current output interrupted" error
35-Not Calibrated Simulate "Not calibrated" error
36-SensorIncompatib. Simulate "Incompatible Sensor" error
37-ROM Error Simulate ROM error in the transmitter
38-RAM Error Simulate RAM error in the transmitter
39-Sim. HART Freq. Simulation of a HART frequency
40-SIL Simulate "Self check alarm" error
41-Conductivity Simulate "Conductivity alarm" error
42-Elec.Coated Simulate "Electrode deposits" error