JUMO flowTRANS MAG H01, Руководство по эксплуатации

Страница: 161 / 260

161
10 Error messages
10 Error messages
10.1 Calling up the error description
Further information about the occurred error can be called up at the Information level.
1. Use to switch to the Information level.
2. Use or to select the "Diagnostics" submenu.
3. Use to confirm your setting.
The first line shows the area where the error has occurred.
The second line shows the unique error number.
The next lines show a brief description of the error and information for the troubleshooting.
10.2 Error statuses and alarms
10.2.1 Error
Process display
Electronic
unit
Operator menu
Diagnostics
....Operator Page 1
....Operator Page
2
Back Select
Electronic unit
F1
2 3.3 2 1
Brief description
Information
Back Exit
Error no./
area Text in the LCD display Cause Remedy
F254.038
Electronics RAM error in Transmitter Error in the transmitter electronics
unit Replace electronics or contact
manufacturer
Contact service
F253.037
Electronics ROM error in Transmitter Error in the transmitter electronics
unit Replace electronics or contact
manufacturer
Contact service
F252.017
Sensor No Sensor Memory Incorrect wiring of terminals D1
and D2 Check the wiring of terminals D1
and D2
Check wiring Cable short-circuit or cable break
on D1 or D2 wires If an old measured value trans-
ducer without SensorMemory is
connected, plug the jumper on the
backplane in the "ON" position.
Check switch SW3? Jumper SW3 is not correctly
plugged into the backplane
Old sensor connected without
SensorMemory