Atmos ACD 03, Руководство по эксплуатации

Страница: 270 / 292

Operation manual - EN
www.atmos.eu
EN - 270
ACD03/04
CURRENT ROOM TEMPERATURE ADJUSTMENT
To adjust the current room temperature, turn the control knob.
To increase the required room temperature by 0,5 to 3 K (°C) compared to the
value set in ACD03/04 controller, turn the control knob clockwise (
+
).
To decrease the required room temperature by 0,5 to 3 K (°C) compared to
the value set in ACD03/04 controller, turn the control knob anticlockwise ( - ).
If the control knob is in the horizontal position (on the largest dot), the
temperature correction is zero (off).
One dot = 1 K (°C) - the desired temperature can be changed (corrected) by
0.5 K (°C).
SWITCHING OPERATING MODES
Use the button to switch from one mode to another one. This is done by
briefly pressing the button repeatedly until the desired mode (indicated by
the light diode) is set.
You can switch between the following four operating modes:
Permanent mode - COMFORT (day)
In this mode, the heating circuit is permanently regulated to the COMFORT temperature (day) set in
the ACD03/04, taking into account the position of the rotary knob (required temperature correction).
Temperature correction is active when the diode is permanently on.
Automatic mode - AUTO
In this mode, the heating circuit is permanently regulated according to the program set in the
ACD03/04, taking into account the position of the rotary knob (required temperature correction).
Temperature correction is active in all day/night modes when the diode is permanently on.
Automatic mode with temporary correction
In this mode, the heating circuit is permanently regulated according to the program set in the
ACD03/04, taking into account in short term the position of the rotary knob (required temperature
correction).
Temperature correction is active only during the duration of the current block - the diode is perma-
nently on. After changing the time block (see the setting in the ACD03/04 controller), the correction
turns off and the room unit switches automatically to normal AUTO mode - - the diode flashes.
ATTENTION: the flashing diode in the normal AUTO mode means, that the room unit operates
according to the values (temperatures) set in the ACD03/04 controller without taking into account the
position of the rotary knob (without correction).
To reactivate the temperature correction, turn the knob by more than 0.5 K (°C), or briefly press the
button . If the control knob is in the horizontal position (on the largest dot), the temperature correc-
tion is zero (off) and this kind of operation (temporary correction) cannot be set. Also, simply turning
the knob to the largest dot (“0”) will exit the temporary correction mode and switch to operation
(mode) AUTO - .
13. R
oom units