TECO JSDG2S Series, User Manual

Page: 365 / 718

7-3
7-2 Parameter Function List

System Parameter (Cn0 □□ )
Parameter Code Name and Function Unit RS485 Index
★
●
Cn001 Control Mode Selection - 0001H 2001H
★
Cn002.0
Auxiliary function—Digitalinput contact SON function
selection
- 0002H 2002H
★
Cn002.1
Auxiliary function—Digitalinput contact CCWL &
CWL function selection
★
Cn002.3 EMC Re-set Mode Selection
-- Cn003 Mechanical Brake Signal Output Time ms 0003H 2003H
★
Cn004.0
Motor Rotation Direction Definition (from the Motor
Load End)
- 0004H 2004H
★
Cn005 Encoder Signal Dividing Output pulse 0005H/0006H 2005H
-- Cn006.0 Analog monitor output MON1 (Note 1)
- 0007H 2006H
-- Cn006.1 Analog monitor output MON2 (Note 1)
-- Cn007 Speed Reached Determined Value rpm 0008H 2007H
-- Cn008.0 Brake Mode
- 0009H 2008H
-- Cn008.1 Forced action of mechanical brake
★
Cn009.0 CW/CCW Drive Prohibited Method
- 000AH 2009H
-- Cn009.1 Drive prohibition abnormal protection (AL.014) setting
-- Cn009.2
Alignment setting when power is connected to the
linear motor for the first time
-- Cn009.3
Analog voltage over-temperature protection function
settings
-- Cn010 CCW Direction Torque Command Limit Value % 000BH 200AH
-- Cn011 CW Direction Torque Command Limit Value % 000CH 200BH
-- Cn012 External Regenerative Resistor Power Setting W 000DH 200CH
-- Cn013 First Set Notch Filter Frequency Hz 000EH 200DH
-- Cn014 First Set Notch Filter Quality Factor - 000FH 200EH
-- Cn015.0 Switching Determination Type Selection of PI/P Mode
- 0010H 200FH
-- Cn015.1
Switching Determination Type Selection of Two Stage
Gain Mode
-- Cn016 Switching Condition of PI/P Mode (Torque Command) % 0011H 2010H
-- Cn017 Switching Condition of PI/P Mode (Speed Command) rpm 0012H 2011H
-- Cn018
Switching Condition of PI/P Mode (Acceleration
Command)
rps/s 0013H 2012H
-- Cn019
Switching Condition of PI/P Mode (Position Error
Command)
pulse 0014H/0015H 2013H
-- Cn020 Switching Delay Time 2 of Two Stage Gain Mode 0.2ms 0016H 2014H
-- Cn021
Switching Condition of Two Stage Gain Mode (Torque
Command)
% 0017H 2015H
-- Cn022
Switching Condition of Two Stage Gain Mode (Speed
Command)
rpm 0018H 2016H
-- Cn023 Switching Condition of Two Stage Gain Mode rps/s 0019H 2017H