TECO JSDG2S Series, User Manual

Page: 104 / 718

3-18
dn-04 (Software Version Display)
The User can use dn-04 to know the current Software Version of this Device, the Panel Display
Description is as follows:
Steps
Operation
Key
LED Display Screen
after Operation
Description
1
Turn on
Power
When the power is turned on, Enter the
Status
Display Screen .
2
Press MODE Key 2 times to enter Diagnostic
Parameters
.
3 Press UP Key 3 times to select dn-04 Item.
4
Press and hold the ENTER Key for 2 seconds, enter
the Display
Software Version Screen, the Software
Version is 2.80.
5
Press MODE Key 1 time to jump back to the
Parameter Selection Screen.
dn-05 (JOG Mode Operation)
Attention
• The JOG speed is based on Sn201 (Internal Speed Command 1) to operate; therefore,
Sn201 must be set before executing this function.
• No matter the motor is excited by using digital input contact SON or not, it will be excited
immediately after entering JOG mode.
The User can use dn-05 to operate JOG operation, the operating instructions are as follows:
Steps
Operation
Key
LED Display Screen
after Operation
Description
1
Turn on
Power
When the power is turned on, Enter the Status
Display Screen .
2
Press MODE Key 2 times to enter Diagnostic
Parameters .
3 Press UP Key 4 times to select dn-05 Item.
4
Press and hold the ENTER Key for 2 seconds to enter
JOG Mode , and the Motor is excited immediately.
5
Press and hold the UP Key, the Motor rotates in the
currently defined positive direction.
6
Press and hold the DOWN Key, the Motor rotates in
the currently defined negative direction.
7
Press MODE Key 1 time, jump back to the Parameter
Selection Screen, the Motor releases excitation.