Mounting
3.7 Mounting the terminating module
ET 200pro distributed I/O system
Operating Instructions, 03/2013, A5E00335544-08
61
Mounting the FESTO valve terminal on the pneumatic interface module
1.
Place the FESTO valve terminal on the connection plate. The undulatory edges on the
connection plate and the pneumatic interface module must fit together.
2.
From below, attach the connection plate with screws (2 Nm torque) to the FESTO valve
terminal. To do so, use the size 1 cross-tip screwdriver and the four 3x16 recessed head
screws.
3.
Press the flat gasket onto the bottom of the FESTO valve terminal. Make sure that the flat
gasket is seated correctly in the center.
4.
Place the FESTO valve terminal with the connection plate on the pneumatic interface
module. The undulatory edges are on the LED side.
5.
Screw the connection plate to the pneumatic interface module (2 Nm torque). To do so,
use the size 2 cross-tip screwdriver and the 5x30 recessed head screws.
Figure 3-10 Mounting the FESTO valve terminal on the pneumatic interface module
Note
There are two O-rings mounted on the connection plate; these seal the space between
the connection plate the electronic module. If you replace the pneumatic interface module
you must also replace the two O-rings size 5x1.2.
