Mounting
3.6 Installing the pneumatic interface module
ET 200pro distributed I/O system
Operating Instructions, 03/2013, A5E00335544-08
59
Requirements
●
The interface module is mounted onto the rack.
●
All pneumatic interface modules must be mounted on the right side of the interface
module.
●
The pneumatic interface module is mounted in the corresponding bus module (as-
delivered state).
●
In the as-delivered state there is a screw on the FESTO valve terminal for attaching the
functional earth. This screw is not needed when the FESTO valve terminal is used in the
ET 200pro and must be removed prior to mounting.
Note
For compliance with degree of protection IP65, you must install a flat gasket between the
FESTO valve terminal (CPV10 or CPV14) and the pneumatic interface module
(16 DO DC 24V CPV10 or 16 DO DC 24V CPV14).
The flat gasket is not shipped with the FESTO valve terminal (CPV10 or CPV14); it must
be ordered separately from Festo AG & Co. KG. The order numbers can be found in the
Required tools
●
Cross-tip screwdriver, size 1
●
Cross-tip screwdriver, size 2
Required accessories
●
FESTO valve terminal CPV10 or CPV14
●
4 recessed head screws 3x16 (supplied together with pneumatic interface module)
●
4 recessed head screws 5x30 (supplied together with pneumatic interface module)
