Mounting
3.7 Mounting the terminating module
ET 200pro distributed I/O system
62
Operating Instructions, 03/2013, A5E00335544-08
3.7
Mounting the terminating module
Introduction
The ET 200pro is terminated using a terminating module. The terminating module must be
mounted to enable operation of the ET 200pro.
Requirements
●
You have mounted all electronic modules of ET 200pro.
●
All electronic modules are screwed onto the rack.
Required tools
Cross-tip screwdriver, size 2
Proceed as follows
1.
Mount the terminating module onto the rack.
2.
Slide the terminating module to the left, up to the last electronic module.
Note
Do not screw the terminating module to the rack (two recessed head screws, torque
1.5 N/m) unless you screwed all connection modules to the electronic modules.
Figure 3-11 Mounting the terminating module
