Configuring
5.1 PROFIBUS DP
ET 200pro distributed I/O system
146
Operating Instructions, 03/2013, A5E00335544-08
5.1.3.4
Example of a configuration
Introduction
The example below explains how to configure an ET 200pro configuration using the GSD
file, and how to group digital output modules in a single byte.
ET 200pro configuration
The diagram below shows a practical example of an ET 200pro configuration using slots
2 to 7:
Figure 5-2
Example: Configuring an ET 200pro configuration
Configuration table and address range
The user is free to select the byte addresses of the inputs and outputs, if the configuration
software supports this. The bit addresses result automatically from the sequence of the
grouped modules.
The table below shows which modules have been grouped and the corresponding address
range.
Slot
Module
Grouping
I/O address
Inputs
Outputs
2
6ES7142-4BD00-0AA0
4DO DC24V
Yes
0.0 to 0.3
3
6ES7142-4BD00-0AA0*
4DO DC24V
0.4 to 0.7
4
6ES7142-4BD00-0AA0
4DO DC24V
Yes
1.0 to 1.3
5
6ES7142-4BD00-0AA0*
4DO DC24V
1.4 to 1.7
6
6ES7141-4BF00-0AA0 8DI
No
0.0 to 0.7
7
6ES7144-4GF00-0AB0 4AI I
No
1.0 to 8.7
