Maintenance and service
7.3 Removing and Inserting Electronic Modules
ET 200pro distributed I/O system
162
Operating Instructions, 03/2013, A5E00335544-08
Electronic module type change
1.
Remove the two screws from the front, right side top and bottom, of the connection
module using a crosstip screwdriver.
2.
Remove the connection module alongside with the electronic module from the bus
module.
3.
While pressing the interlock button on the top of the electronic module, pull the
connection module upwards and out of the electronic module.
4.
Use the pointed pliers to remove one half of the coding key from the connection module
(top right).
5.
Insert the (suitable) connection module into the electronic module (other type).
6.
Insert the connection module with the electronic module into the bus module and screw it
down.
7.
Change the configuration with HW Config and download it to the DP master.
DANGER
If you change the coding, this can result in dangerous plant conditions.
See also
