Mounting
3.5 Mounting the Electronic Module
ET 200pro distributed I/O system
Operating Instructions, 03/2013, A5E00335544-08
57
Proceed as follows
1.
Clip the electronic module onto the rack. Make sure that the mechanical interlock
engages.
2.
Apply some pressure on the connector of the bus module (not on the electronic module!),
then slide the electronic module to the left to engage it with the interface module, or on
the previous electronic module.
Note
Points to note when installing:
•
The electronic module may not become skewed when you move it.
•
You will need to apply some more pressure in order to engage the module with the
interface module or previous electronic module and to achieve appropriate seal
tightness.
Figure 3-7
Mounting electronic modules
See also
Replacing a bus module (Page 164)
