Samsung Ubigate iBG3026, Configuration Manual, Page: 517 / 718

Ubigate iBG3026 Configuration Guide/Ed.00
© SAMSUNG Electronics Co., Ltd.
475
(Continued)
Step Command Purpose
8 timing {wait-wink|wink-
wait|wink-duration|delay-
duration|delay-start } timing-
value
To change timing parameters.
wait-wink - Specifies maximum amound
of time to wait wink for Outbound Call
wink-wait - Specifies maximum wink-wait
duration, in milliseconds, for a wink-start
signal
Valid entries are from 100 to 5000. The
Default is 200
wink-duration - Specifies maximum wink-
signal duration,in milliseconds, for a wink-
start signal
delay-duration - Specifies the delay signal
duration for delay-dial signaling in
milliseconds. Valid entries are from 100 to
5000. The default is 2000
delay-start - Specifies minimum delay
time, in milliseconds, from outgoing seizure
to outdial address. Valid entries are from 20
to 2000. The default is 300.
9 timeouts timer-name timer-
value
To change timeouts parameters
initial - Sets the number of seconds that
the system waits between the caller input of
the initial digit and the subsequent digit of
dialed string.
A valid entry is from 0 to 120. The default is
10
interdigit - Configures the number of
seconds that the system waits after the
caller has input the initial digit or a
subsequent digit of the dialed string. If the
timeout ends before the Destination is
identified, a tone sounds and the call ends.
This value is important when using
variable-length dial peer destination
patterns(dial plans). The
seconds argument
is the interdigit timeout wait time in seconds.
A valid entry is an integer from 0 to 120.
The default is 5.