Samsung Ubigate iBG3026, Configuration Manual

Page: 618 / 718

CHAPTER 33. Routing and Digit Manipulation
576
© SAMSUNG Electronics Co., Ltd.
(Continued)
Command Purpose
dtmf-relay { inband | h245-alphanumeric | rtp-
nte | sip-notify | sip-info | queued-digits }
Example)
sbm/configure/…/voip num#
dtmf-relay rtp-nte
(Optional) Configures the tone that
sounds in response to
a keypress on a touch-tone
telephone. Dual tone
multifrequency(DTMF) tones are
compressed at one end
of a call and decompressed at the
other end.
fax rate { 2400 | 4800 | 7200 | 9600 | 12000 |
14400 }
Example)
sbm/configure/…/voip
num # fax rate 12000
(Optional) Specifies the
transmission speed of a fax to be
sent to this dial peer
The
14400 keyword, which is the
default, specifies the highest
possible transmission speed
supported by the voice rate.
playout-delay mode { adaptive | fixed [value] |
system }
Example)
sbm/configure/…/voip
num # playout-delay
mode adaptive
(Optional) Specifies the type of
jitter buffer playout delay
to use.
playout-delay { maximum | minimum | nominal }
<20-200>
Example)
sbm/configure.../voip
num # playout-delay
maximum 190
(Optional) Specifies the amount of
time that a packet is
held in the jitter buffer before it is
played out on the audio
path.
preference value
Example)
sbm/configure.../voip
num # preference 1
(Optional) Configures a
preference for the POTS dial peer.
The valid range is 0 through 10,
where the lower the number, the
higher the preference.
tech-prefix string
Example)
sbm/configure.../voip
num # tech-prefix #34
(Optional) Specifies that a
particular technology prefix be
prepended to the destination
pattern of this dial peer.