Samsung Ubigate iBG3026, Configuration Manual

Page: 565 / 718

Ubigate iBG3026 Configuration Guide/Ed.00
© SAMSUNG Electronics Co., Ltd.
523
Step Command Purpose
1 voice-port slot/sub-
slot/port:ds0-group-
no
To set up the attribute values of created ds0-
group, enter voice-port configuration mode.
2 shutdown Shuts down the voice port to manipulate
‘timeslots’ and ‘signal cas’ command.
3 calling-number
outbound range
string1 string2
Specifies ANI to be sent out when the T1-CAS
fgd-eana command is configured as signaling
type. The string1 and string2 arguments are
valid E.164 telephone number strings.
Only the last four digits are used for specifying
the range(
string1 to string2 ) and for generating
the sequence of ANI by rotating through the
range until
string2 is reached and then starting
from string1 again. If strings are less than four
digits in length, then entire strings are used.
4 calling-number
outbound sequence
[string1] [string2]
[string3] [string4]
[string5] Specifies ANI to be sent out when the T1-CAS
fgd-eana command is configured as signaling
type. This option configures a sequence of
discrete strings(
string1...string5 ) to be passed
out as ANI for successive calls using the dial
peer or voice port. Limit is five(5) strings. All
strings must be valid E.164 numbers, up to 32
digits in length.
5 calling-number
outbound null Suppresses ANI. No ANI is passed when this
voice port is selected.
6 no shutdown Activate the voice port at the final step of
configuration
7 exit -