Samsung Ubigate iBG3026, Configuration Manual

Page: 626 / 718

CHAPTER 33. Routing and Digit Manipulation
584
© SAMSUNG Electronics Co., Ltd.
(Continued)
Command Purpose
secondary-dialtone string
Example)
sbm/configure/dial-plan
/secondary-dialtone #
secondary-dialtone 9
To enable a secondary dial tone, use the
secondary-dialtone command. The maximum
number that could be configured is 10.
Dialed Number Analysis
Dial Plans
Fixed-Length Dial Plans
Since the length of the telephone number in most cases is already known,
fixed-length dialing plan where all the dial-peers possess the fixed length of
destination-pattern is enough in the most voice network. However, the
particular international phone that can be used with different length of
telephone number needs variable-length dial plan.
Variable-Length Dial Plans
Input T-indicator representing timeout at the end of destination of outbound
voice-network dial peer and wait for inputting additional digit after receiving the
Ubigate iBG3026-fixed length of dial string. Timeout letter is ‘T’ in capital letter.
The following dial-peer configuration is the example of configuring T-indicator
to enable variable-length dial string.
dial-peer voice voip 1
destination-pattern 3456T
session-target ip-address ipv4:10.10.6.8
In the above example, Ubigate iBG3026 waits inputting the additional digit
which is undefined after receiving the number 3456. If inter digit time does
not exceed, inputting digit up to the maximum of 31 is possible. If inter digit
time exceeds, Ubigate iBG3026 connects call.
The basic value of inter digit timeout is 10 seconds. If this value does not change,
it takes 10 seconds of call setup time per each call before timer completes. Thus, it
is necessary to regulate inter digit time by using ‘
timeouts interdigits ’ voice-port
mode command if users want to use variable-length dial plan.