Samsung Ubigate iBG3026, Configuration Manual

Page: 92 / 718

CHAPTER 7. WAN Interfaces
56
© SAMSUNG Electronics Co., Ltd.
(Continued)
Step Command Purpose
9 Router/configure/module/ct3([slot/port])
# t1 [T1 number] name [Link Name] Sets a Link Name.
10 Router/configure/module/ct3([slot/port])
# end Goes back to the ‘ Router# ’
prompt.
11 Router# show module configuration
ct3 [slot/port]: [T1 number] Shows Fractional T1 information.
Configuring Example
The following example shows the commands used to configure the connection
in the figure.
Router# configure terminal
Router/configure# module ct3 2/0
Router/configure/module/ct3 (2/0)# t1 3 framing esf
Router/configure/module/ct3 (2/0)# t1 3 linecode b8zs
Router/configure/module/ct3 (2/0)# t1 3 yellowalarm generate
Router/configure/module/ct3 (2/0)# t1 3 circuitId CT3
_
T1
_
3
Router/configure/module/ct3 (2/0)# t1 3 contactInfo David
Router/configure/module/ct3 (2/0)# t1 3 description
T1
_
to
_
SEOUL
Router/configure/module/ct3 (2/0)# t1 3 name THIRD
_
T1
_
LINK
Router/configure/module/ct3 (2/0)# end
Router# show module configuration ct3 2/0:3
Configuring CT3 bundle
Configuration of an interface bundle is required for WAN interfaces. Multiple
physical interfaces may be linked to a single interface bundle; multi-link
protocols, including MLPPP and Multilink Frame Relay, make use of NxT1
interfaces to create single logical interfaces. The interface bundle specifies the
physical connection(s) to be linked, an encapsulation protocol(Layer 2) and,
optionally, Layer 3 parameters.