Samsung Ubigate iBG3026, Configuration Manual

Page: 558 / 718

CHAPTER 31. Digital Voice Port
516
© SAMSUNG Electronics Co., Ltd.
(Continued)
Step Command Purpose
8 framing
{
esf | d4 }
Selects frame type for T1 or E1 line.
esf -Extended super frame framing format for T1.
d4 -Super frame framing format for T1
disable -Disables E1 framer.
9 linecode { b8zs |
ami } Specifies the line encoding to use.
The keywords are as follows:
ami- Specifies the alternate mark inversion(AMI)
line code type.(T1 and E1)
b8zs- Specifies the binary 8 zero substitution line
code type.(T1)
10 Exit exit to the global configuration mode. Keep in
mind that no-shutdown is not necessary as the
settings are applied instantly.
11 show module
configuration t1
trunk#
Check out the status of the specified trunks and
the sanity.
trunk# is a simple notation of slot/sub-slot/port,
for convenience.
Create DS0 Groups on a Digital T1 Trunk
This procedure is much like the same as the configuration of E1 trunk.
Step Command Purpose
1 configure terminal Assumes the trunk becomes normal active according
to the steps above. Here the description starts with
configuring CAS signaling to trunk.
2 module t1 trunk# Enter the module configuration mode.
3 cas-ds0-group ds0-
group-no
Enter the ds0-group number to create in this T1
trunk.
4 exit Exit module configuration mode.
5 show voice port
summary Check if ds0-group is normally created.
Ds0-group created in the system is displayed in
the status of
slot/sub-slot/port:ds0-group-no.
v239# show voice port summary
PORT CH SIG-TYPE ADMIN OPER IN STATUS OUT STATUS EC
======== == ========== ===== ==== ============= ============ ==
0/0/0 -- fxs-ls up up on-hook idle y
0/0/1 -- fxs-ls up up on-hook idle y
0/0/2 -- fxs-ls up up on-hook idle y
0/0/3 -- fxs-ls up up on-hook idle y
0/1/0:10 -- --- down -- ---- ---- y