Samsung Ubigate iBG3026, Configuration Manual

Page: 481 / 718

Ubigate iBG3026 Configuration Guide/Ed.00
© SAMSUNG Electronics Co., Ltd.
439
(Continued)
Step Command Purpose
3 - grq: Gatekeeper Request(GRQ)
message counter
- rai: Resource Availability Indication(RAI)
message counter
- rrq: Registration Request(RRQ)
message counter
-
urq: Unregistration Request(URQ)
message counter
- value:How long the gateway waits for a
message from the gatekeeper before
timing out, in seconds.
Range: 1 to 30
4 ras retry {all | arq | drq | grq | rai
| rrq | urq}
value
Example)
/configure/voice/service/h323#
ras retry rrq 5
Sets RAS retry conditions. Keywords are
as above. The argument is as follows:
-
value:Number of times that the gateway
resends messages to the gatekeeper
after timeout.
Range: 1 to 10.
5 Exit
Example)
/configure/voice/service/h323#
exit
Exits the current mode
How to configure RRQ TimeToLive
‘ras rrq-ttl’ command specifies the time which should be considered as that
H.323 gateway is running after a gatekeeper receives the lightweight RRQ for
the last time. H.323 gateway sets this value(TimeToLive value) within a RRQ
message and sends it to a gatekeeper. If the lightweight RRQ is not sent out
from H.323 gateway within the specified time, a gatekeeper determines that
the H.323 gateway has a problem, and changes the status to a unregistration
status.
You can set the TimeToLive value to RRQ message in the following way.
Configuration Steps
−
configure terminal
−
voice service h323
−
ras rrq-ttl
−
exit