Samsung Ubigate iBG3026, Configuration Manual

Page: 374 / 718

CHAPTER 27. VoIP Gateway Management
332
© SAMSUNG Electronics Co., Ltd.
Detailed Steps
Step Command Purpose
1 configure terminal
Example)
# configure terminal
Enters global configuration mode.
2 voip-gateway
Example)
/configure# voip-gateway
Enters voip-gateway configuration
mode.
3 host ip-address ip-address
Example)
/configure/voip-gateway# host ip-
address 90.90.90.90
Sets source ip address for signaling
and media streams.
4 exit
Example)
/configure/voip-gateway# exit
Exits the current mode
Enabling or Disabling Voip Services
There are two ways of enabling or shutting down VoIP service. One uses a
shutdown command in voip-gateway configuration mode, the other one uses a
shutdown command in sip-ua configuration mode or h323-gateway
configuration mode. The shutdown command in a sip-ua configuration mode
enables or disables only the sip service and the shutdown command in a h323-
gateway configuration mode enables or disables only the H323 service; and
the shutdown command in a voip-gateway configuration mode enables or
disables not only sip service, but also H323 service, that is, the entire voip call
service. This section describes only the shutdown command in voip-gateway
configuration mode.
How to Enable or Disable All Voip call services
The procedure to enable or disable all voip call services including SIP service
is as follows. If you want to terminate the current call together with stopping
the service, use the forced parameter.