Samsung Ubigate iBG3026, Configuration Manual

Page: 616 / 718

CHAPTER 33. Routing and Digit Manipulation
574
© SAMSUNG Electronics Co., Ltd.
Configuring Voice Class Sip/H323
The voice class that you assign to the dial peer must be configured using the
voice-class sip/h323 in global configuration mode. You can assign one voice
class to each VoIP dial peer. If you assign another voice class to a dial peer, the
last voice class assigned replaces the previous voice class.
Followings are commands that could be configured in ‘voice class sip’ mode.
Command Purpose
offer call-hold { conn-addr | dir-send | dir-inact }
Example)
sbm/configure/voice/class/sip
num # offer call-
hold conn-addr
(optional) Specifies the call hold
request value.
rel1xx { supported | require | system | disable }
Example)
sbm/configure/voice /class/sip
num # rel1xx
supported.
(optional) Specifies the
rel1xx
value.
uri { sip | sips }
Example)
sbm/configure/voice/class/sip num# uri sip
(optional) Specifies the uri value.
url { system | sip | tel }
Example)
sbm/configure/voice/class/sip num# url sip
(optional) Specifies the url value.
Followings are commands that could be configured in ‘voice class h323’ mode.
Command Purpose
h225 call-start {fast|slow|system} Specifies the H.323 call setup
method.
h225 early-h245 {on|off|system} Specifies whether to perform the
normal H.245 procedure before or
after CONNECT message.