Samsung Ubigate iBG3026, Configuration Manual

Page: 480 / 718

CHAPTER 29. H.323 Gateway Management
438
© SAMSUNG Electronics Co., Ltd.
How to configure RAS Retries and Timers
‘ras timeout’ command sets the time(in second) for H.323 gateway to wait
before resending a RAS message to gatekeeper. ‘ras retry’ command specifies
the number of retransmissions of RAS message when the specified timeout
value is exceeded. The default value for timeout and retry counter value is
suitable for most networks. These commands are recommended to used when
the RAS message transmission between H.323 gateway and its interworking
gatekeeper has a problem due to network environment.
The procedure of setting the timeout and retry count values for each RAS
message is as follows.
Configuration Steps
−
configure terminal
−
voice service h323
−
ras timeout
−
ras retry
−
exit
Detailed Steps
Step Command Purpose
1 configure terminal
Example)
# configure terminal
Enters global configuration mode.
2 voice service h323
Example)
/configure # voice service h323
Enters ‘voice service h323’ configuration
mode.
3 ras timeout {all | arq | drq | grq |
rai | rrq | urq}
seconds
Example)
/configure/voice/service/h323#
ras timeout rrq 3
Sets RAS timeout conditions. Keywords
and argument are as follows:
-
all: All RAS message counters that do
not have explicit values configured
individually. If no ras timeout all is
entered, all values set to the default
except the individual values that were
configured separately.
- arq: Admission Request(ARQ) message
counter
-
drq: Disengage Request(DRQ) message
counter