Samsung Ubigate iBG3026, Configuration Manual

Page: 557 / 718

Ubigate iBG3026 Configuration Guide/Ed.00
© SAMSUNG Electronics Co., Ltd.
515
4.
For T1 linecoding, choose either B8ZS or AMI .
5.
For the T1 clock source, choose either internal or line . Keep in mind
that different PBXs have different requirements on the clock source.
Configuration of clock source is only used in module command.
6.
Configure line signaling and interregister signaling for CAS.
7.
Customize the configuration with the cas-custom command.
This procedure is much like the same as the configuration of E1 trunk.
Step Command Purpose
1 show voice card all List all the voice cards installed in the system.
If you find any of the WTE_XX card you can
choose the one to use a T1 trunks card.
2 show module
configuration all Displays all the digital trunk active in the system.
So if you use this command it helps you to
recognize the carrier-types of the trunks installed
in the system.
3 configure terminal Enter the global configuration mode to advance
the T1 setting.
4 system carrier-type
slot # t1
Input the slot# which is qualified to be T1 trunk
card.
And if the previous carrier-type of the slot is
configured T1, rebooting is not required.
Otherwise the system will prompt you to reboot
the system for the change to take effect.
5 configure terminal -
6 module t1 trunk# Specify the T1 trunk that you want to configure
physical layer settings.
trunk# is a simple notation of slot/sub-slot/port,
for convenience.
7 clock_source
{ internal | line } Configures the clock source.
line -Specifies that the clock-facility on this port
derives clocking from the external source to
which the port is connected(generally the CO).
internal -(Optional) Specifies that the clock is
generated from the voice card’s internal clock-facility.