Samsung Ubigate iBG3026, Configuration Manual

Page: 551 / 718

Ubigate iBG3026 Configuration Guide/Ed.00
© SAMSUNG Electronics Co., Ltd.
509
(Continued)
Step
Command Purpose
4 country name
[use-defaults]
Using the country default command, after setting
of the parameters as a default value used in a
specific country, and using the command of each
CLI, it is possible to tune each command.
5
ani-digits
Specifies the number of ANI digits expected to
be collected.
6 answer-signal Specifies answer signal to be used which can be
group-A or group-B.
7 caller-digits Specifies the number of digits needed to be
collected before it requests ANI.
8 default Sets a command to its default setting.
9 dnis-digits Specifies the expected number of DNIS digits.
10 invert-abcd Specifies the inversion of the ABCD bits before
tx and after rx.
11 ka Specifies the KA signal code ranging from 1 to 15.
12 kd Specifies the KD signal code ranging from 1 to 15.
13 metering Specifies sending a metering pulse when the
gateway is making an outgoing call.
14 nc-congestion Specifies the noncompelled congestion signal.
15 request-category DNIS digits to be collected before requesting a
line category.
16 unused-abcd Specifies unused ABCD bit values.
17 exit Exit the cas-custom configuration mode.
18 exit Exit the voice-port configuration mode.