Samsung Ubigate iBG3026, Configuration Manual

Page: 410 / 718

CHAPTER 28. SIP Gateway Management
368
© SAMSUNG Electronics Co., Ltd.
(Continued)
Step Command Purpose
3 destination-pattern dest-pattern
Example)
/configure/ dial-peer/voice/voip 100#
dest-pattern 1234
Sets a destination pattern.
4 session target sip-server
Example)
/configure/ dial-peer/voice/voip 100#
session target sip-server
Sets the session target as sip-
server.
5 exit
Example)
/configure/dial-peer/voice/voip 100#
exit
Exits the current mode
Configuring SIP Registrar
This section describes how to set the SIP Registrar used in a Stand-Alone
mode. Together with SIP Registrar setting, you can register POTS dial-peer to
each SIP Registrar using a register command in a POTS dial-peer
configuration mode.
Restrictions for SIP Registrar
You can set SIP Registrar only when Call Manager is not set already. You
cannot set SIP Registrar in a Call Manager Inter-working mode or Survivable
Telephony mode. To set SIP Registrar, first you must cancel the call-server setting
using no call-server ip-address command. This changes the operation mode to
Stand-Alone mode.
How to Configure SIP Registrar
You can set the SIP Registrar in the following way.
Configuration Steps
−
configure terminal
−
voip-gateway
−
sip-ua
−
registrar
−
exit
−
exit