REXROTH IndraDrive Fc FCS01, Operating Instructions Manual

Page: 92 / 238

11-4
Parameterization Rexroth IndraDrive FCS01.1
DOK-INDRV*--FCS01*****-IB01_EN-P
11.1 Status Indication
In the following, the frequency converter is referred to by the abbreviation
FC .
Parameter Setting value / description / note
Device Supervisor
Parameter
record
P000 Status Indication
0.01 ... 9999 In the display of the standard control panel, the operating value selected in parameter
P001 is indicated
online
.
Depending on what is required, important information on the drive's operating state can be
read out.
P001 Selection of indicator value
0 ... 63
[ 0 ]
0 = Actual frequency [Hz] ; this is the output frequency currently supplied by the
FC.
1 = Speed [1/min] ; this is the actual speed calculated by the FC.
2 = Setpoint frequency [Hz] ; this is the output frequency corresponding to the
applied setpoint value. It does not have to correspond to the current output
frequency.
3 = Power [A] ; this is the current output power measured by the FC.
4 = Torque current [A] ; this is the torque-forming output current of the FC.
5 = Output voltage [V AC] ; this is current AC voltage supplied by the FC at the
output.
6 = DC bus voltage [V DC] ; this is the internal DC voltage of the FC. This is
dependent, among other factors, on the value of the mains voltage
7 = cos ϕϕϕϕ ; this is the currently calculated value of the power factor.
8 = Apparent power [kVA] ; this is the current apparent power calculated by the FC.
9 = Active power [kW] ; this is the current active power calculated by the FC.
10 = Torque [%] ; this is the current torque calculated by the FC.
11 = Field [%] ; this is the current field in the motor calculated by the FC.
12 = Operating hours ; time in which mains voltage is applied at the FC.
13 = Operating hours release; time in which the FC is released.
14 = Analog input 1 [%]; this is the current value applied at analog input 1 of the
FC.
15 = Analog input 2 [%]; this is the current value applied at analog input 2 of the
FC.
16 = reserved
17 = reserved
18 = reserved
19 = Heat sink temperature (°C); current temperature of the FC heat sink.
20 = Motor capacity utilization [%]; average motor capacity utilization, based on
the known motor data (P201…P209).
21 = Brake resistor capacity utilization [%]; average brake resistor capacity
utilization, based on the known resistor data (P556…P557).
22 = … 63 reserved