REXROTH IndraDrive Fc FCS01, Operating Instructions Manual

Page: 135 / 238

Rexroth IndraDrive FCS01.1 Parameterization
11-47
DOK-INDRV*--FCS01*****-IB01_EN-P
Parameter Setting value / description / note Device Supervisor Parameter record
P709 Voltage analog input 1
0.00 ... 10.00 V Indicates the value least measured of analog input 1.
P710 Voltage analog output
0.0 ... 10.0 V Indicates the value least rendered of analog output 1. (0.0 ... 10.0V)
P711
Status multi-function
relay
Indicates the current status of the pilot relay. 0000 ... 01FF (hex)
Bit 0 = Relay 1
Bit 1 = Relay 2
Bit 2 = reserved
Bit 3 = reserved
P712 Voltage analog input 2
0.00 ... 10.00 V See parameter P709.
P714 Operating hours
0.10 ... 9999.99 h This parameter indicates how long the mains voltage has been applied to the FC.
P715 Release hours
0.00 ... 9999.99 h This parameter indicates how long the FU has been released.
P716 Current frequency
-400.0 ... 400.0 Hz Indicates the current output frequency.
P717 Current speed
-9999 ... 9999 rpm Indicates the motor speed calculated by the FC.
P718
... - 01
... - 02
... - 03
Current setpoint
frequency
-400.0 ... 400.0 Hz Indicates the frequency specified by the setpoint value (also refer to Chapter 14.1,
Setpoint Processing in FSC01).
... - 01 = current setpoint frequency from the setpoint source
... - 02 = current setpoint frequency after processing in the FC status machine
... - 03 = current setpoint frequency after frequency ramp
P719 Current power
0.0 ... 999.9 A Indicates the current output current.
P720 Current torque current
-999.9 ... 999.9 A Indicates the currently calculated torque-determining output current (active current).
negative values = regenerative, positive values = motor-driven
P721 Current field power
-999.9 ... 999.9 A Indicates the currently calculated field current (reactive current).