REXROTH IndraDrive Fc FCS01, Operating Instructions Manual

Page: 124 / 238

11-36
Parameterization Rexroth IndraDrive FCS01.1
DOK-INDRV*--FCS01*****-IB01_EN-P
Parameter Setting value / description / note Device Supervisor Parameter record
P509 Source control word
0 ... 9
[ 0 ]
Selection of the interface through which the FC is controlled.
0 = Control terminals or keyboard control
**
with the standard control panel and
the Comfort control panel, when P510 = 0, or via bus I/O bits.
1 = Only control terminals
*
; controlling the FC is possible only via the digital and
analog inputs, or via BUS I/O bits.
2 = USS control word *; the control signals (release, sense of rotation, …) are
transferred via the RS485 interface, and the setpoint value via the analog input or
the fixed frequencies.
3 = reserved
4 = Profibus control word *
5 = reserved
6 = CANopen control word *
7 = DeviceNet control word *
8 = reserved
9 = CAN Broadcast *
*) Keyboard control via the operating elements is blocked, continued parameterization is
possible.
**) If communication is faulty in case of control via keyboard (time out 0.5s),the FC will
block without error message.
P510
... -
... -
Source setpoint values
S
Selection of the setpoint value source to be parameterized:
[01] =
Source main setpoint value
[02] =
Source secondary
setpoint value
Selection of the interface through which the FC receives its setpoint values.
0 ... 8
[ 0 ]
0 = Auto: The source of the secondary setpoint
value is automatically derived from the
setting of parameter P509 >interface<.
1 = Control terminals, digital and analog
inputs control the frequency, also fixed
frequencies.
2 = USS
3 = reserved
4 = Profibus
5 = reserved
6 = CANopen
7 = DeviceNet
8 = reserved
P511 USS Baud rate
S
Setting of the transmission rate (transmission speed) via the interface RS485. All bus
nodes must have the same Baud rate setting.
0 ... 3
[ 3 ]
0 = 4800 baud
1 = 9600 baud
2 = 19200 baud
3 = 38400 baud
P512 USS address
0 ... 30
[ 0 ]
Setting of the FC bus address.