9-26
Indications and Operation of the Function Modules
Rexroth IndraDrive FCS01.1
DOK-INDRV*--FCS01*****-IB01_EN-P
Terminating resistor:
Terminating resistor is
activated
Terminating resistor
is not activated
Fig. 9-22:
Terminating resistor
The use of line type A results in the following lengths of a bus segment:
Transmission
speed[kBit / s]
Line length[m]
Line
resistance[m
Ω
Ω
Ω
Ω
/
m]
Line cross
section[sqmm]
(AWG)
1000
< 40
70
0.25 ...0.34 / 23, 22
500
40 .. 300
< 60
0.34...0.6 / 22, 20
100
300 .. 600
< 40
0.5...0.6 / 20
50
600 .. 1000
< 26
0.75...0.8 / 18
Fig. 9-23:
Transmission speed
Note:
Only when the specified line parameters are observed, the
guaranteed transmission speeds or transmission distances
can be maintained without any problems.
Cable design
Cable specification
Line type A acc. To EN 50 170
Cable design
Twisted two-wire line, single-shielded as a minimum
(also see specification for RS 485)
Recommended
cable type
Surge impedance: 135 ... 165
Ω
Capacitance per unit length < 30 pF / m
Loop resistance 110
Ω
/ km
Strand diameter 0.64 mm
Strand cross-section > 0.34sqmm
Shielding
minimum requirement single-shield; placed on both
sides;
Wiring arrangement,
distances, shielding
Inside and outside of control cabinets at least 20 cm
distance to other lines with voltages > 60V;
Fig. 9-24:
Bus cable requirements
Note:
Shield terminal: Connection of the PE of the frequency
converter for suppression of faults on the bus lines
Terminating resistor
Transmission speed
Bus cable requirements
Summary of Contents for IndraDrive Fc FCS01
