REXROTH IndraDrive Fc FCS01, Operating Instructions Manual

Page: 112 / 238

11-24
Parameterization Rexroth IndraDrive FCS01.1
DOK-INDRV*--FCS01*****-IB01_EN-P
Parameter Setting value / description / note Device Supervisor
Parameter
record
15 = External brake
16 = Converter is running
17 = Current limit
18 = Torque current limit
19 = Frequency limit
20 = Setpoint value reached
21 = Failure
22 = Warning
23 = Overcurrent warning
24 = Overtemperature warning motor
25 = Torque current limit active
26 = Value of P541, external control
27 = Regenerative torque current limit
28 = ... 29 reserved
34 = ... 43 reserved
44 = Bus in bit 0
45 = Bus in bit 1
46 = Bus in bit 2
47 = Bus in bit 3
48 = Bus in bit 4
49 = Bus in bit 5
50 = Bus in bit 6
51 = Bus in bit 7
52 = Output via bus
P419 Scaling of analog output
P
-500 ... 500 %
[ 100 ]
analog functions P418 (= 0…14, 30, 31)
This parameter is used to adjust analog output to the desired operation range. The
maximum analog output (10V) corresponds to the scaling value of the respective selection.
With a constant operating point, it follows that if this parameter is increased from 100% to
200%, the analog output voltage is reduced by half. Then, 10 volt output signal
correspond to double the nominal value.
With negative values, the logic is reversed. Then, a setpoint value of 0% is rendered at the
output with 10V, and -100% with 0V.
digital functions P418 (= 15…27, 44… 52)
With the function current limit (= 17), torque current limit (= 18) and frequency limit (=
19), this parameter can be used to set the switching threshold. The 100% value refers to
the corresponding nominal motor value (also see P435).
With a negative value, the output function is rendered negativated (0/1
→
1/0).
P420 Function digital input 1
0 ... 62
[ 1 ]
Release right as factory setting
Various functions may be programmed. Please refer to the following table.
P421 Function digital input 2
0 ... 62
[ 2 ]
Release left as factory setting
Various functions may be programmed. Please refer to the following table.