REXROTH IndraDrive Fc FCS01, Operating Instructions Manual

Page: 134 / 238

11-46
Parameterization Rexroth IndraDrive FCS01.1
DOK-INDRV*--FCS01*****-IB01_EN-P
Parameter Setting value / description / note Device Supervisor Parameter record
P705
... - 01
...
... - 05
DC bus volt. last error
1…5
S
0 ... 1000 V DC This parameter saves the DC bus voltage that was supplied at the moment of error.
The values of the last 5 errors are saved.
With the standard control panel, the corresponding memory location 1…5 (array
parameter) must be addressed and confirmed with the ENTER key to read the stored
value.
P706
... - 01
...
... - 05
Parameter record last
error 1...5
S
0 ... 3 This parameter saves the parameter record identification that was active at the
moment of error. The data of the last 5 errors is saved.
With the standard control panel, the corresponding memory location 1…5 (array
parameter) must be addressed and confirmed with the ENTER key to read the stored
error code.
P707
... - 01
... - 02
Software-Version/ -
Revision
0.0 ... 9999.9
Contains the software version of the FC, cannot
be modified.
... - 01 = version number (1.1)
... - 02 = revision number (2)
P708 Status digital inputs
Indicates the status of the digital inputs in binary/hexadecimal code. This indication
can be used to check the input signals.
Bit 0 = digital input 1
Bit 1 = digital input 2
Bit 2 = digital input 3
Bit 3 = digital input 4
Bit 4 = digital input 5
Bit 5 = reserved
Bit 6 = reserved
Bit 7 = digital function analog input 1
Bit 8 = digital function analog input 2
Bit 11-8 Bit 7-4 Bit 3-0
Minimum value
0000
0
0000
0
0000
0
binary
hex
Maximum
value
0001
1
1111
F
1111
F
binary
hex
000000000 ...
111111111 (binary)
or
0000 ... 01FF
(hexadecimal)
Standard control panel: the binary bits are indicated as a hexadecimal
value.
Comfort control panel: the bits are indicated from right to left in
ascending order (binary).