REXROTH IndraDrive Fc FCS01, Operating Instructions Manual

Page: 79 / 238

Rexroth IndraDrive FCS01.1 Indications and Operation of the Function Modules
9-23
DOK-INDRV*--FCS01*****-IB01_EN-P
Fig. 9-16: FCC01.1F-PB2-NNNN
BR (green) BUS ready; communication w/o problems
Status LEDs
BE (red) BUS error, operational fault
Supply voltage is 24V DC
±
25%. The 24V connection is effected by
means of insulation piercing connecting device. The maximum line cross
section is 0.75 sqmm. With flexible lines, use the supplied connector
sleeves. (cross section 0.75 sqmm, length 12 mm)
The assignment of the 9-pole D-SUB socket is identical in the function
modules FCC01.1F-PB1 and -PB2.
GND
RTS
6
1 5
9
+5V
A- Daten
B- Daten
Fig. 9-17: Pin assignment FCC01.1F-PB1 und –PB2
The terminating resistor for the last bus node is in the Profibus standard
connector; there, it can be activated by means of the switch if required.
Select the 4 PPO types by means of the rotating encoding switch for the
PPO type. If set to PGM , the value from parameter P507 of the frequency
converter is used. Power supply to the frequency converter must be
activate.
Select the Profibus address hexadecimal from 0 to 7F by means of the
rotating encoding switches
"x10" and "x1" . Decimally, this equals 0 to
127. If set to PGM , the value from parameter P508 of the frequency
converter is used. Power supply to the frequency converter must be
activate. Setting "+100" (on PPO rotating encoding switches) increases
selected address (X10, X1)by "+100".
e.g. Profibus address = 30
dec
= 1E
hex
-> x10=1, x1=E
e.g. Profibus address = 130
dec
= 1E
hex
-> x10=1, x1=E; PP0=+100
Connection of the supply
voltage
Assignment of the 9-pole D-
SUB socket
Terminating resistor
Setting of the PPO type
Setting the Profibus address