Optical Systems Design OSD2524, User Manual

Page: 311 / 402

OPTICAL SYSTEMS DESIGN
DOC ID: 10120001
OSD2524 OPERATOR MANUAL
PAGE 311
This page shows the ACL status by different ACL users. Each row describes the ACE that is
defined. It is a conflict if a specific ACE is not applied to the hardware due to hardware
limitations. The maximum number of ACEs is
256
on each switch.
User
Indicates the ACL user.
ACE
Indicates the ACE ID on local switch.
Frame Type
Indicates the frame type of the ACE. Possible values are:
Any
: The ACE will match any frame type.
EType
: The ACE will match Ethernet Type frames. Note that an Ethernet Type based ACE will not get
matched by IP and ARP frames.
ARP
: The ACE will match ARP/RARP frames.
IPv4
: The ACE will match all IPv4 frames.
IPv4/ICMP
: The ACE will match IPv4 frames with ICMP protocol.
IPv4/UDP
: The ACE will match IPv4 frames with UDP protocol.
IPv4/TCP
: The ACE will match IPv4 frames with TCP protocol.
IPv4/Other
: The ACE will match IPv4 frames, which are not ICMP/UDP/TCP.
IPv6
: The ACE will match all IPv6 standard frames.
Action
Indicates the forwarding action of the ACE.
Permit
: Frames matching the ACE may be forwarded and learned.
Deny
: Frames matching the ACE are dropped.
Filter
: Frames matching the ACE are filtered.
Rate Limiter
Indicates the rate limiter number of the ACE. The allowed range is
1
to
16
. When
Disabled
is
displayed, the rate limiter operation is disabled.
CPU
Forward packet that matched the specific ACE to CPU.
Counter
The counter indicates the number of times the ACE was hit by a frame.
Conflict
Indicates the hardware status of the specific ACE. The specific ACE is not applied to the hardware due to
hardware limitations.
Buttons