Optical Systems Design OSD2524, User Manual

Page: 223 / 402

OPTICAL SYSTEMS DESIGN
DOC ID: 10120001
OSD2524 OPERATOR MANUAL
PAGE 223
QOS INGRESS PORT POLICERS
Configuration
→
QoS
→
Port Policing
This page allows you to configure the Policer settings for all switch ports.
The displayed settings are:
Port
The port number for which the configuration below applies.
Enable
Enable or disable the port policer for this switch port.
Rate
Controls the rate for the port policer. This value is restricted to 100-3276700 when "Unit" is kbps or fps,
and 1-3276 when "Unit" is Mbps or kfps. The rate is internally rounded up to the nearest value supported
by the port policer.
Unit
Controls the unit of measure for the port policer rate as kbps, Mbps, fps or kfps.
Flow Control
If flow control is enabled and the port is in flow control mode, then pause frames are sent instead of
discarding frames.