Optical Systems Design OSD2524, User Manual

Page: 100 / 402

OPTICAL SYSTEMS DESIGN
DOC ID: 10120001
OSD2524 OPERATOR MANUAL
PAGE 100
Policy ID
Select the policy to apply to this port. The allowed values are
0
through
255
. The default value is 0.
Action
Select whether forwarding is permitted ("Permit") or denied ("Deny"). The default value is "Permit".
Rate Limiter ID
Select which rate limiter to apply on this port. The allowed values are
Disabled
or the values
1
through
16
. The default value is "Disabled".
EVC Policer
Select whether EVC policer is enabled or disabled. The default value is "Disabled". Note that ACL rate
limiter and EVC policer can not both be enabled.
EVC Policer ID
Select which EVC policer ID to apply on this port. The allowed values are
Disabled
or the values
1
through
256
.
Port Redirect
Select which port frames are redirected on. The allowed values are
Disabled
or a specific port number
and it can't be set when action is permitted. The default value is "Disabled".
Mirror
Specify the mirror operation of this port. The allowed values are:
Enabled
: Frames received on the port are mirrored.
Disabled
: Frames received on the port are not mirrored.
The default value is "Disabled".
Logging
Specify the logging operation of this port. Notice that the logging message doesn't include the 4 bytes
CRC. The allowed values are:
Enabled
: Frames received on the port are stored in the System Log.
Disabled
: Frames received on the port are not logged.
The default value is "Disabled". Note: The logging feature only works when the packet length is less than
1518(without VLAN tags) and the System Log memory size and logging rate is limited.
Shutdown
Specify the port shut down operation of this port. The allowed values are:
Enabled
: If a frame is received on the port, the port will be disabled.
Disabled
: Port shut down is disabled.
The default value is "Disabled".
Note: The shutdown feature only works when the packet length is less than 1518(without VLAN tags).
State
Specify the port state of this port. The allowed values are:
Enabled
: To reopen ports by changing the volatile port configuration of the ACL user module.
Disabled
: To close ports by changing the volatile port configuration of the ACL user module.
The default value is "Enabled".
Counter
Counts the number of frames that match this ACE.