Optical Systems Design OSD2524, User Manual

Page: 103 / 402

OPTICAL SYSTEMS DESIGN
DOC ID: 10120001
OSD2524 OPERATOR MANUAL
PAGE 103
This page shows the Access Control List (ACL), which is made up of the ACEs defined on this
switch. Each row describes the ACE that is defined. The maximum number of ACEs is
256
on
each switch.
Click on the lowest plus sign to add a new ACE to the list. The reserved ACEs used for internal
protocol, cannot be edited or deleted, the order sequence cannot be changed and the priority is
highest.
ACE
Indicates the ACE ID.
Ingress Port
Indicates the ingress port of the ACE. Possible values are:
All
: The ACE will match all ingress port.
Port
: The ACE will match a specific ingress port.
Policy / Bitmask
Indicates the policy number and bitmask of the ACE.
Frame Type
Indicates the frame type of the ACE. Possible values are:
Any
: The ACE will match any frame type.
EType
: The ACE will match Ethernet Type frames. Note that an Ethernet Type based ACE will not get
matched by IP and ARP frames.
ARP
: The ACE will match ARP/RARP frames.
IPv4
: The ACE will match all IPv4 frames.
IPv4/ICMP
: The ACE will match IPv4 frames with ICMP protocol.
IPv4/UDP
: The ACE will match IPv4 frames with UDP protocol.
IPv4/TCP
: The ACE will match IPv4 frames with TCP protocol.
IPv4/Other
: The ACE will match IPv4 frames, which are not ICMP/UDP/TCP.
IPv6
: The ACE will match all IPv6 standard frames.
Action
Indicates the forwarding action of the ACE.
Permit
: Frames matching the ACE may be forwarded and learned.
Deny
: Frames matching the ACE are dropped.
Filter
: Frames matching the ACE are filtered.
Rate Limiter
Indicates the rate limiter number of the ACE. The allowed range is
1
to
16
. When
Disabled
is
displayed, the rate limiter operation is disabled.
Port Redirect