Optical Systems Design OSD2524, User Manual

Page: 175 / 402

OPTICAL SYSTEMS DESIGN
DOC ID: 10120001
OSD2524 OPERATOR MANUAL
PAGE 175
STATION CLOCK CONFIGURATION
The Synce module may have a Station clock input and/or a Station clock output.
Clock input frequency
If supported by the Synce HW, the station clock input frequency can be configured, the possible
frequencies are:
1,544 MHz, 2,048 MHz or 10 MHz
Clock Output frequency
If supported by the Synce HW, the station clock output frequency can be configured, the possible
frequencies are:
1,544 MHz, 2,048 MHz or 10 MHz
SYNCE PORTS
For each possible port on switch.
Port
The port number to configure.
SSM Enable
Enable and disable of SSM functionality on this port.
Tx SSM
Monitoring of the transmitted SSM QL on this port. Transmitted QL should be the Quality Level of the
clock generated by this node. This means the QL of the clock source this node is locked to
Rx SSM
Monitoring of the received SSM QL on this port. If link is down on port, QL_LINK is indicated. If no
SSM is received, QL_FAIL is indicated
1000BaseT Mode
If PHY is in 1000BaseT Mode then this is monitoring the master/slave mode. In order to receive clock on
a port, it has to be in slave mode. In order to transmit clock on a port, it has to be in master mode
Buttons
: Click to save changes.
: Click to undo any changes made locally and revert to previously saved values.
: Refreshes the displayed table starting from the input fields.